Professional manufacturer of cuplock scaffolding provides you with high quality cuplock
Usually, cuplock scaffolding is supported by door frame, connecting rods, cross, scaffolding and arm lock parts. Can also have a supporting base, bracing, horizontal reinforcing rod, rod, sealing rod sweeps the floor, and so on. In the construction process, plays an important role. For the use of this kind of construction tools, need to do a good job of building in advance. Look at the building include build Settings required below.
Buildings include the erection sequence should be: basic preparation, place the plate, place the base and put up two common single door frame, install a crossbar, laid scaffolding, was repeated in such order to install door frame, cross bar, scaffolding, etc.
Scaffolding must consolidate the basis of firm, slag and put a layer of 100 mm should be honest, to do well at the same time the corresponding drainage slope, prevent water phenomenon.
For this building include shall make building, from one end to the other end of the scaffolding needed in next step after scaffolding, and then to set up.
The build-up to the next step in the direction of the opposite. In the position of the scaffold endpoint cuplock scaffolding base insert two common door frame parts, and then cross bar to fixed installation, lock, even at the same time in the set-up of the door frame after every build a cross, then install the crossbars and lock plate.
For cuplock scaffolding, be sure to set its reliable connection between the building and the spacing of connecting piece no more than three steps on horizontal plane, no more than three steps on the vertical plane.
TAG:   cuplock scaffolding